Roland V-1SDI, Руководство пользователя

Страница: 11 / 40

11
Basic Operation
Turning the Power On and Off
Once everything is properly connected (p. 8–10), be
sure to follow the procedure below to turn on their
power. If you turn on equipment in the wrong order,
you risk causing malfunction or equipment failure.
* Before turning the unit on/off, always be sure to turn
the volume down. Even with the volume turned down,
you might hear some sound when switching the unit
on/off. However, this is normal and does not indicate a
malfunction.
Turning the Power On
1.
Make sure all devices are turned off.
2.
Press the [POWER] button on the rear panel of
the V-1SDI to turn on the power.
* This unit is equipped with a
protection circuit. A brief interval
(a few seconds) after turning the
unit on is required before it will
operate normally.
3.
Turn on the power for the source devices.
Turn on the power to video cameras or
other source equipment connected to input
connectors on the V-1SDI.
4.
Turn on the power for the output devices.
Turn on the power to projectors or other devices
connected to output connectors on the V-1SDI.
Turning the Power Off
1.
Turn off the power in the sequence of first the
output equipment, and then the sources.
2.
Press the [POWER] button on the V-1SDI to turn
off the power.
MEMO
5
The power to the V-1SDI turns off automatically if
a set interval elapses with no operation performed
(Auto Off function).
If you don’t want the power to be turned off
automatically, disengage the Auto Off function. For
details, refer to “Turning Off the Power Automatically
(Auto Off)” on this page.
Turning Off the Power Automatically
(Auto Off)
Auto Off is a feature that automatically turns off the
power after no operation for a specific period of
time. This helps prevent wasting electrical power.
By factory default, the Auto Off function is set on.
When the states described below persist for 240
minutes, the Auto Off function acts to automatically
turn off the power.
5
No operation performed on the V-1SDI
5
No audio or video input
To turn the Auto Off function off or on, follow the
steps below to change the setting.
MEMO
5
When the power has been turned off by the Auto Off
function, to restart, first press the [POWER] button to
return it to the Off position, then turn on the power.
1.
Display the SETUP menu (p. 12), then select
“AUTO OFF.”
2.
Use the A/B fader to set the Auto Off function
on or off.
Value Explanation
ON
The Auto Off function is turned on. Power is
turned off automatically.
OFF
The Auto Off function is turned off. Power is
not turned off automatically.
3.
Quit the menu (p. 12).
NOTE
5
Any settings that you are in the process of editing will
be lost when the power is turned off. If you have any
settings that you want to keep, you should save them
beforehand.
Executing/Changing Specific Functions at Startup You can execute or change the following functions at
startup of the V-1SDI.
Operation at startup Operation
Returning settings to the factory-default state at startup (p. 30) Hold down the [DSK] and [AUTO] buttons and press the [POWER] button.
Setting “HDCP” on the SETUP menu to “ON” at startup (p. 17) Hold down the [PinP] button and press the [POWER] button.
Setting “HDCP” on the SETUP menu to “OFF” at startup (p. 17) Hold down the [SPLIT] button and press the [POWER] button.