4. Operation
23
How to Load Media
CAUTION
Load roll media correctly.
Otherwise the media may fall and cause injury.
CAUTION
Roll media weighs about 30 kg (66 lb.). To avoid injury, handle with care.
CAUTION
Never load media that weighs more than 30 kg (66 lb.).
The printer may fail to withstand the weight and topple over, or the media may fall
from the unit.
VG series,VS series, RS series, VP series, SP-540i/300i, RA-640, RE-640
1.
Pass the media through the printer.
Move the dancer roller toward the
rear.
Switch on the printer's sub power, and when the screen shown
in the figure appears, press
to select [TU2] (ac-
companying the pull-back operation) or [TU] (not accompanying
the pull-back operation).
[TU2] is available only when you’re using the VS series printer.
VP series, RS series, SP-540i/300i, RA-640, RE-640 or when selecting [TU] with VG
series, VS series:
Make sure the printer's [PREFEED] and [FEED FOR DRY] menu items are each set to
"DISABLE." (For RS series, RA-640 and RE-640, check [FEED FOR DRY] only.)
For information on how to check or change setting values, refer to the user's manual for the printer.
Load roll media onto the printer, then
lower the loading lever.
For information on how to perform loading, refer
to the user's manual for the printer.
After loading, check the following points.
The media is loaded straight.
All areas of the media are taut.
If the media is slack or crooked, raise the loading
lever and reload the media.
SETUP SHEET
TU
OK
Not
OK
Dancer roller
