MIN 610, 620, 630. . . .
MAX 950
MIN600
MAX950
MIN 610, 620, 630. . . .
MAX 960, 970, 980. . . .
MIN600
MAX950
6
Customizing Impact Values
Harder or softer materials
You can customize the impact values and register an item as a new material when the material is
harder or softer than the default values of Dr. METAZA2. Try your own settings if you are not
satisfied with the results even after adjusting the gamma, brightness and/or contrast values.
*Customized values are not reflected in the on-screen preview.
How to customize impact values
1) Open "Print Set Up" from the File menu.
2) Click "Properties" and then "Image Correction".
3) Select Set-a to -e and click "Details" of Material.
4) Increase or decrease the impact value by 10 units.
(Default impact value is MIN. 380, MAX. 540 for brass at Photo mode.)
5) Enter a name to register and click OK.
6) Return to the tag, Material and click on "Save settings". Enter a file name (***.txt) and save the
5)
setting.
7) Click on the "Load Settings" of the Material tag when using this saved setting the next time.
Basic Adjustments: Change both MIN and MAX values
1. If the entire image is dark, the material may be too hard. Increase both MIN and MAX values by
1.
10 units while leaving the material loaded on the work table and impact it over again.
Advanced adjustments: Change either MIN or MAX values to improve the
image impression.
If grayscale is too dark, increase MIN value only.
2. If the entire image is too light (whitish), replace the material, and then decrease both MIN and
2.
MAX values.
Содержание Metaza M PX -60
Страница 1: ...Model MPX Model MPX 60 Operation Guide...
