The adhesive sheet is
placed front side back
on the work table.
The adhesive sheet is
not aligned with the
upper right corner of
the work table.
The workpiece is not
in the center of the
work table.
3
For Best Imprinting Results - Part 1
Yes
No
Loading a material
METAZA is a precision instrument. To obtain the best imprinting results, loading the workpiece
with care is very IMPORTANT. See User’s manual “Part 2 Performing Marking” for instructions
on how to mark materials.
1. Place the adhesive sheet and the material in the correct position
1111
1) Align the upper right corner of the adhesive sheet with the corner of the work table and set
1111
in place.
1111
2) Place the adhesive sheet on the work table so that the widest margin is in front (which is the
1111
screw side).
1111
3) Place the workpiece at the center of the work table where the grid lines cross in the middle.
*If the adhesive sheet is in the wrong position, you will not get a good result.
*If you are a first time user of the METAZA, try using the trial material included in the package
*
first. Should the METAZA impact where it is not desired, refer to the User’s manual Part 5 “The
*
marked position isn’t where desired” for details.
The wide margin
should be in front
Содержание Metaza M PX -60
Страница 1: ...Model MPX Model MPX 60 Operation Guide...
