Manual Version 3.21
Page. 22 of 73
4.7
PARAMETER TABLE
The Upper/Lower Tone Parameters can be reached and edited by:
•
Typing the corresponding number with the numeric keypad 0 – 9
When the Factor you wish to edit appears in the Display, press the VALUE edit button, then change the value
with the
α
Dial.
•
Pressing the PARAM button, rotate the
α
Dial, and the Factor shown in the Display will change in sequence.
When the Factor you wish to edit appears in the Display, press the VALUE edit button, then change the value
with the
α
Dial.
•
Assigning 2 selected Factors to C1 and C2 buttons:
o
Press the PATCH button, press the TONE button, press C1 or C2 button, then select the Factor with
the
α
Dial. In this way 2 different Factors can be controlled in real time with C1 or C2 buttons.
•
Directly and in a more straightforward way with a PG-800 programmer.
(The current, edited Factor will be temporarily shown if MIDI - 42 EDIT DISPLAY is set on the PG-800)
DCO (Digitally Controlled Oscillator)
The DCO is a digitally controlled oscillator that controls the pitch and generates the waveforms that are the sound
source of the synthesizer. Owing to its
digitally controlled system, this offers superior pitch stability compared with a
VCO (Voltage Controlled Oscillator). The JX-10 has 2 DCO’s.
P a r a m e t e r
Data
Value
F u n c t i o n
Programmer
Number
Display
11
DCO 1 RANG
2
’
This is used to change the pitch range of the DCO in
exact one octave steps from 2’ to 16’ (2’,4’,8’,16’). –
8’ is the standard pitch.
DCO-1 Range
4
’
21
DCO 2 RANG
8
’
DCO-2 Range
16
’
12
DCO 1 wf
sawt
This is used to choose the output waveform type of
the DCO. (Sawtooth, Pulse, Square, Noise)
DCO-1 Waveform
puls
22
DCO 1 wf
squa
DCO-2 Waveform
nois
13
DCO 1 tune
+
12
This changes the frequency (pitch) of the DCO, in
semitone steps.
•
Variable Range: ±12 (±1 Octave)
DCO-1 Tune
0
24
DCO 2 tune
DCO-2 Tune
-12
