Roland EGX-30, Руководство пользователя

Страница: 19 / 32

17
5
Tighten the screw securely to secure the cutter in
place.
Gently lower the cutter until the tip of the cutter
touches the surface of the material.
6
Hexagonal
screw driver
Material surface
3
Installing a Tool
The steps for installing a tool are shown below. Follow these steps to install the appropriate tool for the task.
For Engraving (Character Cutter)
* Use SELECT key to choose "ENGRAVER" as the mode.
1
When installing a cutter for engraving, make sure the tip of the cutter protrudes beyond the surface of the material by an amount
equal to the depth of engraving to be performed.
Move the tool carriage to a position over the material surface, then install the cutter.
2
Press the
SET SURFACE
key to lower the tool,
then loosen the screw for the engraving-tool holder.
Provisionally tighten the character cutter in the
engraving-tool holder, and install the engraving-tool
holder on the tool carriage.
Loosen the tool mounting screw and insert the depth
regulator nose in the tool carriage.
Hexagonal
screw driver
Install the depth regulator nose as shown in the
figure.
1. Line up the
protrusion with
the groove on
the front, and fit
it in the groove.
3. Retighten the tool
mounting screw to
secure the nose in
place.
2. Rotate in the
direction of
the arrow.
The spanner included with
the unit is 3 mm (1/8 in.) thick,
and can be used as to check
the width of the space.
Screw
part
3 mm (1/8 in.)
Adjust the screw so to make
this space 3 mm (1/8 in.).
4
Hexagonal
screw driver
2. Rotate in the direction
of the arrow.
1. Turn in the direction
of the arrow to
tighten provisionally.
Engraving-
tool holder
Use the spanner to tighten and secure in place.