Roland DWX-4W, Руководство по установке

Страница: 51 / 64

Steps to Perform Following Installation
49 2. Installation and Setup
2. Installation and Setup

Open the front cover.
Spin the spindle around 10 times in
either direction by hand.
Close the front cover.
Spindle run-in will begin.
The machine status light will flash blue.
The remaining work time will be displayed on VPanel.

When the message shown in the figure appears, the
spindle run-in (long) is complete.
Click [OK].
CAUTION
Do not insert your hands or other objects into the machine or look into
the inside of the machine with the front cover open until the spindle has
come to a complete stop.
If you open the front cover before the spindle comes to a complete stop, an
emergency stop will occur. Due to inertia, the spindle will continue to rotate even
after an emergency stop has occurred. It is dangerous to touch a rotating tool.
Also, the coolant continues to flow until the spindle comes to a complete stop.
Coming into contact with sprayed coolant may be hazardous to your health.
Continue on to "STEP 4: Milling Machine Correction."
STEP 4: Milling Machine Correction
This procedure must be performed by a trained service technician. This work is required not only when install-
ing the machine but also when moving the machine to a different location. Contact your authorized Roland
DG Corporation dealer to perform such work.
To service technician
Refer to the service note, perform automatic correction (rotation axis corr ATC magazine
correction).