11
Tone Parameters (Upper/Lower Tone Menu)
Partial Parameters
(Part-1, Part-2)
Restriction of the available parameters caused
by Structure
Depending on what Structure is used, the available
parameters may be different.
1
Some parameters included in a Partial that uses
a PCM sound generator are invalid.
2
With Ring Modulation, some parameters in
Partial 2 will automatically become the same as
for Partial 1. Therefore, the values shown in the
display are irrelevant with the actual values.
&
&
&
&
“TVA (Time Variant Amplifier)”
&
“*Init*”
(Initialize)
PITCH
(WG Pitch)
WG Pitch
(Pitch)
S3 WG Pitch
CorsC5 Fine 00
Cors
(Pitch Coarse)
Sets the standard pitch of a Partial in semi-tone steps. The
standard pitch is the pitch at C4 (middle C) key.
Value:
C1–C7
Fine
(Pitch Fine)
Makes a fine adjustment to the standard pitch.
Value:
-50–+50
0
s2
s1
-1
-1/4
-1/2
1/8
1/4
3/8
1/2
5/8
3/4
7/8
1
5/4
3/2
2
1
0
-1
2
+3
Pitch
(Octave)
Middle C (C4)
KF
(Keyfollow (pitch))
Usually, the keyboard to a synthesizer assigns a semi-tone to each
key. This parameter can change the pitch ratio as show below. The
value represents how many octaves are changed over 12 keys.
Value:
-1, -1/2, -1/4, 0, 1/8, 1/4, 3/8, 1/2, 5/8, 3/4, 7/8, 1, 5/4, 3/2, 2,
s1, s2
* s1 or s2 may be selected for slightly stretching octaves.
s1:
Pitch 1 cent higher than one octave.
s2:
Pitch 5 cents higher than one octave.
WG Mod
(Modulation)
S3 WG Mod
LFO OFF ENV (+)
LFO
(LFO Mode)
Normal
“-”
is selected.
Selects one of the following four vibrato modes.
Value:
OFF, (+), (-), A&L
Indication
Function
OFF
No vibrato is obtained.
(+)
Vibrato is on.
(-)
Vibrato is on but inverted.
A&L
Vibrato can be obtained only by Aftertouch and Bender Lever.
ENV
(P-ENV Mode)
“+”
is selected.
“-”
is selected.
Selects one of the following three modes, determining how the
pitch is controlled by P-ENV.
Value:
OFF, (+), (-)
Indication
Function
OFF
No alteration.
(+)
Pitch changes with the set P-ENV curve.
(-)
Pitch changes with the P-ENV curve inverted.