Roland Camm-1Pro GX-300, Руководство пользователя

Страница: 52 / 102

Details of the Origin-point Location and Cutting Area
3
Part of Practice
50
The Location of the Origin Point Immediately After Loading Material (When [ROTATE]
is set to [0deg])
“ROLL” (When using roll material)
The origin point is set at the location where the mate-
rial is loaded, near the left pinch roller.
“F-EDGE” (When performing cutting from as close as possible to the front edge of
the material)
Set the origin point at a location having a margin of 30
mm (1-3/16 in.) from the front edge of the material.
“R-EDGE” (When using the front-loading feature)
Set the origin point at a location having a margin of 30
mm (1-3/16 in.) from the trailing edge of the material.
When in this state, the cutting area is zero.
“PIECE” (When using flat material)
After length in the direction of material feed is de-
tected, movement 30 mm (1-3/16 in.) back from the
front edge of the material is performed, and the origin
point is set near the left pinch roller.
* When the length of the material is 1,600 mm (63
in.) or longer, the material is determined to be roll
material. The origin point is set in the same way as
for “ROLL” above.
* For detailed information about the cutting area, see the following page.
Material
(0. 0)
Pinch roller
Depends on length
Margin
Material
(0. 0)
Pinch roller
30 mm Margin
(0. 0)
Pinch roller
Material
Material
(0. 0)
Pinch roller
Margin
30 mm
30 mm
30 mm