Roland Camm-1Pro GX-300, Руководство пользователя

Страница: 36 / 102

Loading the Material (Roll Material)
2
Basic Operation
34

Switch on the power.

When the left figure is displayed. Press to
select [ROLL].
Press .
The SETUP LED lights up (setup state), and the horizontal width of the
material is detected and shown on the display. Setup is now complete. For
more information about selecting material, refer to the page 49 “Details of
the Origin-point Location and Cutting Area.”
Be sure to use the left and right pinch rollers
When securing material, be sure to use the left and right pinch rollers,
and position them properly above the grit rollers. If the pinch rollers
are improperly positioned, the width of material may not be detected
accurately, or the error shown at right may occur. If this happens, either unload the material (refer to
the page 42 “When Cutting is Completed”), or press
to clear the error, then reposition the
pinch rollers correctly to load the material precisely.
When using roll material, before you perform cutting you need to pull out the required length of
material from the roll. For more information, refer to the page 40“Material Test Feed.”
Be sure to use the middle pinch roller for the wide material.
In using such wide sheet material as it has a grit mark in between the right and left pinch rollers when
it is secured with them, be sure to use the middle pinch roller. Without using it, the stable feed of the
material is difficult to maintain, and it increases the potential of deteriorating the cutting quality.

For GX-640, use the two middle pinch rollers with which it is equipped. (For GX-500/400, it is
equipped with one middle pinch roller.)

The GX-300 has no middle pinch roller.
POWER LED
lights up