20
Have the following parts to hand:
9.10 Fitting the rail to the panels
6 mm Allen key
Rail
2. Insert the 6 mm Allen key supplied into the apertures on the top side of the four panels. To prevent
damage to the thread, first turn the Allen key half a turn to the left. The screw will then „drop“ into the
thread. Tighten the rail‘s screws clockwise to a tightening torque of approx. 3 Nm (hand-tight).
2. Insert the supplied 6 mm Allen key into the holes in the top of the
panel supports. Tighten the screws clockwise to a tightening torque
of approx. 3 Nm (hand-tight).
1. Insert the rail‘s four guide pins into the four locator holes on the base plate.
1. Insert the rail‘s four guide pins into the four locator holes on the panel supports.
