Rointe Capri CWI350DHWK4, Инструкция по эксплуатации и монтажу

Страница: 5 / 20

5
2. INSTALLATION AND CONNECTING
Attention! Improper installation and connection of the appliance may make it hazardous for the health and
life of consumers. It may cause grievous and permanent consequences, including but not limited to physical
injuries and/or death. Improper installation and connection of the appliance may also lead to damage to the
consumers’ property /damage and/ or destruction/, or to that of third persons, as a result of, but not limited
to flooding, explosion and/or fire.
2.1. Installation.
The appliance shall be installed in premises where the temperature does not fall below 4°С
and there is no danger for the water to freeze.
The appliances have been hydraulically tested during manufacture. A little water may leak from the ingoing
and the leading-out pipes of the appliance when the protection caps are removed.
2.2. Models designed for the kitchen
(supplied with a mixing tap). It is not allowed to use connecting
fittings that are not from the manufacturer or have not been agreed upon with them. The following order
shall be adhered to during installation:
· The mixing tap is installed to the water supply system so that the handles are positioned horizontally – fig.1
· For the cordless models – the supply conductors have to be connected to the appliance beforehand. It is
necessary to follow the instructions in item 3.3 of Section VI: Connecting to the electricity grid.
· The appliance is installed directly to the mixing tap (1) by using the 2 nuts with gaskets (2) – fig. 1. Unscrew
the nuts up to two or three turns. Place the pipes of the appliance in the nuts openings and press slightly until
stop piece. Screw the nuts firmly in order to tighten the connection.
· Install thespout.
· The appliance has to be filled with water. The supply voltage has to be switched off. Turn the red-colour
handle to let water run to the heater. Wait until a continuous water jet starts running from the spout.
· Once the appliance is full of water, you can switch on the supply voltage.
2.3. Models for the bathroom
The following order shall be adhered to during installation:
· Select the position for the shower head holder by taking into account the height - “h” fig.2 desired by you
for the position of the shower.
Fig.1