4. UNPACKING / ASSEMBLY
Check the correct number of components has been supplied, as in FIGURE 1.
Check that the apparatus is complete, undamaged and correctly assembled. Any damaged or defective parts must be replaced before use.
-- Open the Autodim PAPR unit and check the spark arrestor, pre-filter and filter, FIGURE 2 (A)
NOTE: If it is broken, please replace it.
- Replace the filter back into the casing if it´s in good condition. FIGURE 2 (B)
Place the spark arrestor into the filter cover.
Place the pre-filter into the above combination.
Click the above combination into the Turbo unit.
NOTE: Make sure that the filter is properly placed into the casing while installing.
WARNING: The filter can only be fitted to the turbo unit. DO NOT directly fit the filter to the helmet/hood.
- Install the Autodim PAPR blower on the belt.
Remove the released buckle out of the belt. FIGURE 3 (A)
Draw the fasten belt out from the waist connector. FIGURE 3 (B)
Slide the fasten belt into the blower unit through the two blower slots. FIGURE 3 (C)
Slide the fasten belt back into the waist connector. FIGURE 3 (D)
Put the release buckle back into the belt. FIGURE 3 (E)
Adjust the belt tightness so it can fit well with your shoulder and waist. FIGURE 3 (F)
NOTE: Check that belt is securely fastened.
