6
Assembly of Grills and Blade
-
Remove blade fixing nut and grill connection nut.
-
Fix the rear grill and connection nut to the motor shaft, then tighten the nut to place back grill
tightly
-
Place main fan blade to fit in the hub and channel on engine axle. Be sure fan blade is placed to
the pin on engine axle. Then, place second fan to engine axle. It is very important to place blades
fully. Otherwise, fan turns idle during operation and may damage product.
-
Use fasten nut for fan blade to hold blades in place fully.
-
Use the screw to fix plastic ring, just until it is fine.
-
Assemble the ring to front grill.
Operations
Buttons on control panel can be used as same as with the ones on remote control.
On/Off
: It is to turn on your fan. Once you press the button, your device starts to work. Press this
button again if you need to turn off your device.
Speed:
It is to set desired fan speed level. (1
-
Low, 2
-
Medium, 3
-
High).
Mode:
There are 3 wind modes. You can set any mode by pushing mode button. Normal Wind:
Fan delivers air constantly with high, medium or low speed by MODE button. Natural Wind: Fan
delivers air to simulating natural wind. Wind variations from strong to weak or vice
-
versa make
you feel fresh and comfortable naturally. Sleep Wind: Wind weakens step by step until
in low
natural speed status.
Timer:
When this key is touched repeatedly, time for air delivery increases step by step of each
0,5 hour and up to 7,5 hours in 15 steps. For instance, if you want to set your fan for 5,5 hours,
you should push this button until you see 0,5 – 1 and 4 hours lighten on control panel. Don’t push
TIMER, when you will operate your fan continuously.
Oscillation:
If you want to enlarge air flow area in your room, press Oscillation button. Press it
again to stop oscillation.
Setting Airflow Angle
• Moving the fan head either up or down can make further wind direction enhancements.
Adjusting Height
• Do turn off the fan before lift or lower its height.
