Rohm Lapis EASE1000 V2, Руководство пользователя

Страница: 17 / 33

EASE1000 V2 User’s Manual
2.5.2 Target System Circuit Configuration
The circuit configuration to connect a target LSI with EASE1000 V2 is different depending on the specifications of
the target LSI. Use an appropriate configuration according to the LSI user's manual.
This section describes some notes when connect a target LSI with EASE1000 V2.
2.5.2.1 ML62Q1000 series is connected as target LSI
- Do not connect the parts which RESET_N pin is fixed to a High level.
A pull-up resistor is connectable to the RESET_N pin. For more details, please refer to Chapter "On chip
debug function" in the user's manual for the target LSIs.
- When using P00/TEST0 pin, be sure to set P00 as an input mode by an application program.
If P00 is set as an output mode, it becomes impossible to use EASE1000 V2.
2.5.2.2 ML610QXXX or ML620QXXX is connected as target LSI
2.5.2.2.1 Recommended circuitry using RESET_N pin and TEST pin
- Do not connect the parts which RESET_N pin is fixed to a High level.
A pull-up resistor is connectable to the RESET_N pin. For more details, please refer to Chapter "On chip
debug function" in the user's manual for the target LSIs.
- Do not connect any parts to TEST pin.
2.5.2.2.2 Recommended circuitry using TEST1_N pin and TEST0 pin
- Do not connect any parts to TEST1_N pin and TEST0 pin.
- EASE1000 V2 controls reset of a target LSI, do not reset from a RESET_N pin during debugging.
16