Rohl GKIT1655 Скачать руководство пользователя страница 19

Страница: 19 / 20

www.rohlhome.com

Consult your local ROHL showroom for additional information and specifications. For complete warranty details and a list of showrooms, go to www.rohlhome.com.

INSTALLATION INSTRUCTIONS

Issue

•

• CARTRIDGE REPLACMENT

The filter cartridge in your instant hot tap system needs to be changed every six months in order to

ensure the system works at its optimum performance.

Changing the filter cartridge is a simple matter:

1. Switch off the heater tank either at the mains or by pressing

the centre button on the heater tank touch screen.

***Important Notice*** – run off all hot water until
just cold water is coming out of the tap.

2. Place a small bowl under the filter housing sump to catch the
small amount of water that will be released when removing the

filter housing sump.

3. Turn the filter housing sump anti-clockwise a quarter turn, to

allow the filter housing sump to drop down from the filter
housing head.

4. Once the sump is removed, unscrew the filter housing cap

from the sump and tip any water out of the sump into the bowl
or sink.

5. Remove the old filter by pulling the filter from the cap.

6. Dispose of the old filter in the normal household waste bin.

Remebering to keep the filter insert as you will need

this for the replacement filter.

7. Fit the new filter by pushing the filter insert into the top of
the filter then into the cap; you may need to wet the ‘O’ seals in

the top of

    the filter as shown in the attached drawing referenced A.
    Always inspect the 'O' seals for damage; for replacements use
    contact details below.

8. Screw the sump back onto the cap (Ensuring that the ‘O’ seal
is in place), referenced B.

9. Push the filter housing sump back into the filter housing head

and turn clockwise until it stops.

Important Notice

The filter is now ready to use – it is vitally important that you

follow the process below to ensure that all air is bled from the
system.

Place a jug under the spout as water will splutter

from the spout until all of the air is expelled

Operate the instant hot tap lever to dispense water, run-off at

least 0.35 gallons of water, let the system rest for at least 30

seconds and run another 0.35 gallons of water, repeat this at
least one more time – your instant hot water tap should now be

ready for use.

You must now thoroughly check the unit for any water
leaks and take this opportunity to check for any excess
wear or damage to the system. If there are no leaks

please continue:

10. Now switch the heater tank back on at the mains, or by

pressing the button in the centre of the heater tank touch
screen.

11. Set the desired temperature by pressing the right hand

button until the desired temperature is displayed (usually 98

degrees)

12. Press the left hand button to confirm the temperature

setting.

13. The heater tank will now heat up to the desired temperature

and once completed the system is ready for use.

FILTER

HOUSING