GUI Reference
R&S
®
ZNB/ZNBT
619
User Manual 1173.9163.02 ─ 38
Remote command:
Define *IDN + *OPT...
Defines a format for the ID string and the option string of the analyzer. The default
strings are automatically adjusted to the selected "Remote Language". The strings can
be queried via
*IDN?
and
*OPT?
, respectively.
●
If the DEFAULT language is activated, the factory ID string
"Rohde&Schwarz,ZNB<Max. Freq>-<Ports>Port,<Serial_no>,<FW_Version> (e.g.
Rohde-Schwarz,ZNB8-2Port,1311.6010.42,12345,1.10.05)" is set. The option
string is a comma-separated list of all installed software and hardware options. The
bit order for transferred binary data is swapped (
FORMat:BORDer SWAPped
).
●
If the PNA language is activated, Agilent-compatible ID and option strings are set.
The bit order for transferred binary data is normal.
●
If one of the HP xxxx languages is activated, HP xxxx-compatible ID and option
strings are set. Binary data is transferred in a device-specific bit order, however,
the bit order can be changed using HP xxxx-specific commands.
The ID and option strings can be changed or reset to the R&S factory ID string.
Remote command:
SYSTem:IDENtify[:STRing]
SYSTem:IDENtify:FACTory
SYSTem:OPTions[:STRing]
SYSTem:OPTions:FACTory
FORMat:BORDer
Advanced ...
Opens a dialog that allows to set the following parameters:
●
"Wait for Data after Sweep" determines the execution behavior of
INITiate[:IMMediate]
commands (see
Chapter 7.3.9, "INITiate Commands"
on page 908).
If enabled, an automatic
*WAI
Chapter 7.2, "Common Commands"
on page 677).
By default this is disabled.
●
"Auto-Align Logical Ports" determines the logical port creation logic.
If enabled (default), logical ports are aligned and must be set from low to high port
(which was the only possibility prior to firmware V1.91). If set to disabled, new ports
can be created freely, like in manual operation.
●
"No Device Clear" suppresses Device Clear (DCL, SDC) GPIB interface mes-
sages.
Setup Softtool
