Rohde & Schwarz ZNB20, Руководство пользователя

Страница: 1184 / 1332

Command Reference
R&S
®
ZNB/ZNBT
1169 User Manual 1173.9163.02 ─ 38
Manual operation: See "Password" on page 616
SYSTem:PRESet[:DUMMy]
Performs a factory preset of all instrument settings (i.e. all open recall sets) or of the
active recall set, depending on the
SYSTem:PRESet:SCOPe
settings. The command is
equivalent to
*RST
and to the action of the PRESET key on the front panel.
Note: If a user-defined preset is active (
SYSTem:PRESet:USER[:STATe] ON
), the
PRESET
key initiates a user-defined preset, while
SYSTem:PRESet[:DUMMy]
and
*RST
still activate the factory preset. If "Align *RST to User Defined Preset" is selected
in the "System Configuration > Presets" dialog and a valid user preset file is available,
*RST
and
SYSTem:PRESet[:DUMMy]
also restore the user-defined settings.
Example: SYST:PRES:SCOP SING
Define the scope of a preset: the active recall set is reset only.
SYST:PRES
Reset the parameters of the current recall set.
Manual operation: See "PRESET HARDKEY" on page 638
SYSTem:PRESet:REMote[:STATe] <arg0>
Defines the behavior of the
*RST
and
SYSTem:PRESet[:DUMMy]
commands.
●
Off (default):
*RST
and
SYSTem:PRESet
restore the factory preset settings.
●
On: If a valid user preset file is available,
*RST
and
SYSTem:PRESet
restore the
user-defined settings.
Parameters:
<arg0>
Manual operation: See "Remote Preset Configuration" on page 605
SYSTem:PRESet:SCOPe <Scope>
Specifies whether a preset (
SYSTem:PRESet[:DUMMy]
;
*RST
) affects the active
recall set only or all open recall sets.
Parameters:
<Scope> ALL | SINGle
ALL
–
all open recall sets are deleted and the recall set "Set1" is
created with default trace and channel settings.
SINGle
–
the settings of the active setup are reset; the name of
the active setup and the parameters of all other setups remain
unchanged.
Example: See
SYSTem:PRESet[:DUMMy]
Manual operation: See "Preset Scope" on page 604
SCPI Command Reference