Command Reference
R&S
®
ZNB/ZNBT
1114
User Manual 1173.9163.02 ─ 38
SOURce<Ch>:POWer<PhyPt>:CORRection[:ACQuire]:VERification:RESult?
Returns (and deletes) the result of the last verification sweep. The response contains
three values:
●
<Channel>
–
calibrated channel, e.g.
Ch 1
for channel no. 1.
●
<Boolean>
–
1 for "calibration passed" (the maximumr offset is below the toler-
ance), 0 for "calibration failed".
●
<MaxOffset>
–
maximum power offset between the measured power at the refer-
ence plane and the "Cal Power" during the verification sweep in dB.
If no verfication sweep is available, or if the result has been queried already, the
response is
0
.
Suffix:
<Ch>
.
Calibrated channel number. This suffix is ignored; the result is
based on the last verification sweep acquired.
<PhyPt>
Calibrated port number. This suffix is ignored; the result is based
on the last verification sweep acquired.
Example:
*RST; :SOURce:POWer:CORRection:NREadings 2
SOURce:POWer:CORRection:COLLect:AVERage:
NTOLerance 0.5
Increase the number of readings and reduce the power toler-
ance to improve the accuracy.
SOURce:POWer:CORRection:ACQuire PORT,1
Perform a source power calibration using port 1 as a source
port.
SOURce:POWer:CORRection:ACQuire:VERification:
RESult?
Query the result of the verification sweep. Possible response:
Ch1 1,9.9E+002
Usage:
Query only
Manual operation:
See
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect:AVERage[:COUNt]
<NoReadings>
Sets a limit for the number of calibration sweeps in the source power calibration. The
command is valid for all channels, ports and external generators. Equivalent command:
SOURce<Ch>:POWer<PhyPt>:CORRection:NREadings
.
Suffix:
<Ch>
.
Calibrated channel number. This parameter is ignored; the limit
applies to all channels.
<PhyPt>
Calibrated port number. This parameter is ignored; the limit
applies to all sources.
SCPI Command Reference
