Voxell
7. MONITORING THE FUNCTION STATUS
VOXELL_UMTS_installation_revG_en.doc
42
7.2. Tonalities
VOXELL also signals the function status and the errors by means of
some audible tones, which can be heard in the handset of the
connected phone.
If the control module of the equipment does not communicate with the
GSM/GPRS/3G modem or if the mobile phone module has no
network signal, VOXELL generates a warning tone. The tone is
represented by a 440 HZ signal: 200 ms tone, 100 ms pause, 200 ms
tone, 500 ms pause.
Tonalities
Significance
200 ms tone, 100ms pause, 200 ms
tone, 500 ms pause
The GSM/3G module is initializing or
not registered
80 ms tone, 80 ms pause
The SIM card requests the PIN code
80 ms tone, 80 ms pause, 80 ms
tone, 80 ms pause, 80 ms tone,
1500 ms pause
The SIM card requests the PUK code
160 ms tone, 160 ms pause
Busy tone
If the SIM card has activated the request for PIN, when the equipment
starts it send the recorded PIN code. If the sent code is not the same,
the equipment goes into a wait status and signals this with a sound.
Now you may enter the PIN code from the phone keyboard. The
connection of the phone is achieved through the FxS interface (check
if the FxS is activated). If the PIN code was incorrectly entered for
three times then it locks up. You must enter the PUK code to unlock
(this phase is also signaled with tone, as shown in the above table).
