Rohde & Schwarz SMM100A, Руководство пользователя

Страница: 526 / 1088

General instrument functions
R&S
®
SMM100A
526 User Manual 1179.1341.02 ─ 05
Settings:
Power-On State ...........................................................................................................526
Display Level as Voltage of EMF ................................................................................ 526
Power-On State
Determines the RF signal output state when the instrument is switched on.
You can disable the RF output signal in general, or start it in the same state as it had
been when it was switched off.
Remote command:
:OUTPut<hw>[:STATe]:PON
on page 696
Display Level as Voltage of EMF
Activates display of the signal level as voltage of the EMF (no-load voltage).
If disabled, the level is displayed as a voltage over a 50 Ohm load.
Note:
The setting is not affected by an instrument preset ([Preset] key or
*RST
) and the
"Save/Recall" function. It is reset only by factory preset.
Remote command:
[:SOURce<hw>]:POWer:EMF:STATe
on page 938
11.1.5 How to set the initial instrument settings
This section describes how to set up the R&S SMM100A initially.
11.1.5.1 Setting the keyboard language
You can select the language of the external keyboard connected to the instrument.
To adjust the keyboard settings
1. Press the [Setup] key.
2. Select "User Interface > Keyboard".
3. Select the "Layout".
The dialog closes and the changes take effect immediately.
Customizing the user interface