Rohde & Schwarz RTE-COM4, Начало работы, Страница: 47 / 123

Trying Out the Instrument
R&S
®
RTE
39 Getting Started 1326.1026.02 ─ 06
4 Trying Out the Instrument
This chapter introduces the most important functions and settings of the
R&S
RTE step by step. The complete description of the functionality and its
usage is given in the "User Manual". Basic instrument operation is described in
Chapter 5, "Operating the Instrument" , on page 75.
Prerequisites
●
The instrument is set up, connected to the mains system, and started up as
described in
Chapter 2, "Preparing for Use" , on page 11.
●
A probe is available.
For these first measurements, you use the internal calibration signal, so you do
not need any additional signal source or instruments. Try out the following:
● Displaying a Basic Signal ................................................................................39
● Acquiring Data .................................................................................................41
● Changing the Waveform Scaling and Position ................................................42
● Zooming into the Display .................................................................................48
● Displaying the Waveform History .................................................................... 50
● Showing Basic Measurement Results .............................................................52
● Performing a Basic FFT Analysis ....................................................................60
● Performing Mathematical Calculations ............................................................63
● Performing a Search ....................................................................................... 65
● Performing a Mask Test .................................................................................. 66
● Printing and Saving Screenshots .................................................................... 69
● Saving Data .....................................................................................................72
4.1 Displaying a Basic Signal
Displaying the input from a signal channel is simple and straightforward. Further-
more, you get to know some basic trigger functions. The R&S
RTE provides wide-
ranging trigger functions to find various signal anomalies, which are described in
the instrument help and in the "User Manual".
1. Press the PRESET key on the front panel (in the SETUP area on the left).
2. Connect the probe to the input connector CH 1.
Displaying a Basic Signal