Rohde & Schwarz R&S ATS1000, Инструкция по эксплуатации, Страница: 17 / 81

Emergencies
R&S
®
ATS1000
17 Instructions Handbook 1179.2983.02 ─ 01
3 Emergencies
Potential emergencies can result from failure of the interlock, which prevents the posi-
tioner from moving when the door is open. If the interlock fails and the positioner
moves while the door is open, use the
Emergency Stop .
3.1 Emergency Stop
To stop the chamber's positioner quickly at any time, interrupt the electric power
source.
To interrupt the electric power source
1. Hit the panic button that interrupts the power source.
See "Power connection requirements" on page 39.
2. If no panic button is installed, do one of the following:
● Pull the power plug out of the mains power socket.
● Pull the C19 connector out of the power supply unit [A221] at the rear of the
chamber.
See
Figure 4-5 .
Interrupting the electric power source has the following effects:
●
The positioner stops moving immediately.
●
The door's [LOCK / UNLOCK] button is no longer lit.
If the door was unlocked before the electric power source was interrupted, the but-
ton light already has gone out.
●
The door's locking system is de-energized, you cannot lock or unlock the door.
●
The power source to the chamber's alignment lasers is interrupted.
●
The power source to any connected test instruments is interrupted only if the panic
button has been configured to switch off these instruments as well.
To reactivate the chamber, proceed as described in Chapter 7.1, "Activating the Cham-
ber" , on page 43.
Emergency Stop