Rohde & Schwarz NRP18A, Руководство пользователя

Страница: 52 / 165

Browser-Based User Interface
R&S
®
NRPxxA(N)
52 User Manual 1177.6017.02 ─ 05
Trigger Source ...............................................................................................................52
└ <Source> ........................................................................................................ 52
└ <Slope> ...........................................................................................................52
Trigger Level ................................................................................................................. 52
Trigger Delay .................................................................................................................52
Dropout ......................................................................................................................... 53
Holdoff ...........................................................................................................................53
Hysteresis ..................................................................................................................... 53
Trigger Source
Groups the trigger source settings.
<Source> ← Trigger Source
Selects the trigger source. See Chapter 9.5.2.3, "Trigger Sources" , on page 73.
Remote command:
TRIGger:SOURce
on page 82
<Slope> ← Trigger Source
Sets the polarity of the active slope of the trigger signal that is externally or internally
applied.
"Positive"
The rising edge of the trigger signal is used for triggering.
"Negative" The falling edge of the trigger signal is used for triggering.
Remote command:
TRIGger:SLOPe
on page 82
Trigger Level
Sets the trigger threshold for internal triggering derived from the test signal.
Remote command:
TRIGger:LEVel
on page 81
TRIGger:LEVel:UNIT
on page 81
Trigger Delay
Sets the delay between the trigger event and the beginning of the actual measurement.
Settings