Rohde & Schwarz NRP18A, Руководство пользователя

Страница: 53 / 165

Browser-Based User Interface
R&S
®
NRPxxA(N)
53 User Manual 1177.6017.02 ─ 05
Remote command:
TRIGger:DELay
on page 79
Dropout
With a positive (negative) trigger slope, the dropout time is the minimum time for which
the signal must be below (above) the power level defined by "Trigger Level".
Remote command:
TRIGger:DTIMe
on page 79
Holdoff
Sets the hold-off time, a period after a trigger event during which all trigger events are
ignored.
Remote command:
TRIGger:HOLDoff
on page 80
Hysteresis
Sets the hysteresis in dB. A trigger event occurs, if the trigger level:
●
Falls below the set value on a rising slope.
●
Rises above the set value on a falling slope.
Thus, you can use this setting to eliminate the effects of noise in the signal for the edge
detector of the trigger system.
Remote command:
TRIGger:HYSTeresis
on page 80
6.5.4 System Settings
Describes the parameters of the general network environment and specific identifica-
tion parameters of the power sensor in the network.
Further information:
●
Chapter 9.11, "Configuring the System" , on page 112
Access: main dialog of the web user interface > navigation pane > "System"
Settings