Preparing for Use
R&S
®
NRP-Zxx
15
Getting Started 1176.8822.02 ─ 04
3. To ensure a maximal measurement accuracy, tighten the RF connector using
a torque wrench with the recommended nominal torque (see the operating
manual of your power sensor).
4.4.2
Connecting the Host Connector of the R&S NRP
‑
Z Power
Sensors
To connect to an adapter
You can use an R&S
NRP
‑
Z3 or R&S
NRP
‑
Z4 adapter.
1. Rotate both cables, so that the red markings on the sleeves of both of them
are at the same position.
2. Insert the host connector of your sensor into the connector of your USB
adapter.
Figure 4-2: Connecting the host connector
1 = R&S
NRP
‑
Z4 in this example
2 = Red marking
3 = Host connector
4 = R&S NRP
‑
Z power sensor
To connect to an R&S
NRP
‑
Z5 sensor hub
► Insert the host connector, red marking upwards, into the SENSOR connector
of your sensor hub.
Connecting the R&S NRP
‑
Z Power Sensors
