Rohde & Schwarz FSW-K40, Руководство пользователя

Страница: 61 / 166

Analysis
R&S
®
FSW-K40
61 User Manual 1173.9286.02 ─ 15
Name ← Select Limit Line
Shows the name of the limit line.
Unit ← Select Limit Line
Shows the unit of the limit line.
Compatible ← Select Limit Line
Shows if the limit line is compatible to the current measurement setup or not.
"Yes" You can use the limit line because it is compatible to the current mea-
surement setup.
"No" You cannot use the limit line because it is compatible to the current
measurement setup.
Visible ← Select Limit Line
Displays a limit line in the diagram area.
You can display up to eight limit lines at the same time.
Remote command:
Display a limit line:
Lower limit:
CALCulate<n>:LIMit<k>:LOWer:STATe
on page 111
Upper limit:
CALCulate<n>:LIMit<k>:UPPer:STATe
on page 113
Query all visible limit lines:
CALCulate<n>:LIMit<k>:ACTive?
on page 109
Check Traces ← Select Limit Line
Turns the limit check for a particular trace on and off.
Remote command:
Assign a limit line to a particular trace:
CALCulate<n>:LIMit<k>:TRACe
on page 112
Activate the limit check:
CALCulate<n>:LIMit<k>:STATe
on page 111
Querying limit check results:
CALCulate<n>:LIMit<k>:FAIL?
on page 110
Using Limit Lines