Rohde & Schwarz FPC1000, Руководство пользователя

Страница: 225 / 291

Remote Control
FPC1000
210
User Manual 1178.4130.02 ─ 02
<m> Marker
If you set the suffix at DELTamarker to 1, or use no suffix, the
R&S FPC1000 interprets this as delta marker 2 because the first
marker has to be a normal marker. If more than one normal
marker (2 to 6) is already active, the command turns these
markers into delta markers. If no delta marker is active yet, the
command activates the delta marker and positions it on the trace
maximum.
Parameters:
<State> ON | OFF | 1 | 0
*RST:
OFF | 0
Example:
//Turn on delta marker 3 or turn marker 3 into a delta marker.
CALC:DELT3 ON
CALCulate<n>:DELTamarker<m>:X
<Position>
This command positions a delta marker on a particular coordinate on the x-axis.
Note that it is possible to place the marker outside the visible trace. In that case, this
value is invalid.
If necessary, the corresponding delta marker is activated first.
Suffix:
<n>
.
irrelevant
<m> Marker
Parameters:
<Position> <numeric value>
The unit depends on the measurement and marker input mode.
Hz for measurements in the frequency domain.
s for measurements in the time domain.
No unit for channel input mode (
CALCulate<n>:MARKer<m>:
FREQuency:MODE
).
Example:
//Delta marker positions are relative to marker 1.
CALC:DELT:MOD REL
//Position delta marker 2 10.7 MHz to the right of marker 1.
CALC:DELT2:X 10.7MHz
//Query the absolute and relative position of delta marker 2.
CALC:DELT2:X?
CALC:DELT2:X:REL?
CALCulate<n>:DELTamarker<m>:X:RELative
<Position>
This command positions a delta marker on a position relative to the reference marker.
If necessary, the corresponding delta marker is activated first.
Remote Commands of the Spectrum Application
北京海洋兴业科技股份有限公司（证券代码：839145） www.hyxyyq.com