Rohde & Schwarz EX-IQ-BOX, Руководство пользователя

Страница: 251 / 418

Remote Control Commands
R&S
®
EX-IQ-BOX
236 User Manual 1409.5570.32 ─ 05
9 Remote Control Commands
In the following, all remote-control commands are presented in detail with their parame-
ters and the ranges of numerical values.
Commands to the respective transmission protocols are described in separate chapters:
●
User Defined
​
chapter 9.3, "User Defined - Remote Control Commands" ,
on page 257
● ​
chapter 9.4, "CPRI Remote Control Commands" , on page 286
For an introduction to remote control, refer to
​
chapter 8, "Remote Control Basics" ,
on page 213.
The remote-control commands are structured in subsystems according to the SCPI syn-
tax, and then listed in alphabetical order.
Addditionally, find a list of all commands for the R&S EX-IQ-BOX at the end of the manual,
see "Alphabetical List of Commands".
9.1 Common Commands
Common commands are described in the IEEE 488.2 (IEC 625-2) standard. These com-
mands have the same effect and are employed in the same way on different devices.
The headers of these commands consist of "*" followed by three letters. Many common
commands are related to the Status Reporting System.
Available common commands:
*CLS
​ .............................................................................................................................236
*IDN?
​ ............................................................................................................................237
*OPC
​ ............................................................................................................................237
*OPT?
​
...........................................................................................................................237
*RCL
​
.............................................................................................................................238
*RST
​
.............................................................................................................................238
*SAV
​
.............................................................................................................................238
ERR?
​
............................................................................................................................238
*CLS <*cls>
CLear Status
Sets the status byte (STB), the standard event register (ESR) and the
EVENt
part of the
QUEStionable
and the
OPERation
registers to zero. The command does not alter the
mask and transition parts of the registers. It clears the output buffer.
Setting parameters:
<*cls> string
Usage: Setting only
Common Commands