Rohde & Schwarz EX-IQ-BOX, Руководство пользователя

Страница: 272 / 418

Remote Control Commands
R&S
®
EX-IQ-BOX
257 User Manual 1409.5570.32 ─ 05
Setting parameters:
<State> string
String parameter to specify the file name with extension
*.savrcl
.
Example: MMEM:STOR:STAT 4,"d:\user\test.savrcl"
Usage: Setting only
9.3 User Defined - Remote Control Commands
This chapter describes all remote-control commands for user defined applications, includ-
ing their parameters and value ranges.
Based on the R&S DigIConf commands, the description is structured according to the
SCPI subsystems. Within each chapter, the order is alphabetical.
As a special feature you can find most of the commands summarized in a set of com-
mands. This is required for test setups of the R&S
EX-IQ-BOX, modell 1409.5505.02,
when not controlled by R&S DigIConf.
A command set defines first the commands of the R&S instruments. See also
​
chap-
ter 9.3.1, "Explanation to the Device Specific SCPI Syntax" , on page 257 for more details.
Specific properties that relate to a particular instrument, are clearly expressed.
The command for R&S DigIConf is always listed as last command, thus directly with the
explanation.
9.3.1 Explanation to the Device Specific SCPI Syntax
This chapter briefly describes the variants in SCPI notation, depending on the controlling
device.
Basically, if you run an R&S EX-IQ-BOX, model 1409.5505.02 directly with an R&S
instrument, you have to set the same parameters as if controlled by R&S DigIConf. Since
the devices communicate directly with each other, however, the transmission direction
must be determined within the command. I.e. there are separate commands defined for
the transmission and the receiver mode.
The following example shows you the notation to use, according to the controlling device.
The
<placeholder>
represents the variants in notation.
User Defined - Remote Control Commands