Rohde & Schwarz EX-IQ-BOX, Руководство пользователя

Страница: 135 / 418

Protocol Settings
R&S
®
EX-IQ-BOX
120 User Manual 1409.5570.32 ─ 05
Trigger Delay
Specify a time delay after the trigger event. Trigger delay is defined clock cycles.
Remote command:
​
[:
​
SOURce<hw>]:
​
EBOX:
​
USER:
​
TRIGger:
​
DELay
​
on page 282
Status
Indicates the current trigger status.
Remote command:
​
[:
​
SOURce<hw>]:
​
EBOX:
​
USER:
​
TRIGger:
​
STATe?
​
on page 283
Arm
Stops the current signal output. It continues either automatically or synchronized, accord-
ing to the used trigger source.
Remote command:
​
[:
​
SOURce<hw>]:
​
EBOX:
​
USER:
​
TRIGger:
​
ARM
​
on page 281
7.1.7 Test
The "Test" tab provides functions for testing the user interface between the R&S EX-IQ-
BOX and the DUT.
Prior to any measurement of an I/Q signal, we recommend that you to check the function
of the data interface.
The R&S EX-IQ-BOX provides both, a test signal generator and a measurement receiver
that supports BER measurement.
The test dialog changes depending on the transmissioni path. If the R&S EX-IQ-BOX is
working as transmitter, the test dialog shows the control elements for the test signal gen-
erator. In receiver mode, the dialog provides the control elements for the test receiver.
Refer for description to
​
chapter 7.1.8, "TX-Test" , on page 120, and to
​
chapter 7.1.9, "Rx-
Test" , on page 123, respectively.
7.1.8 TX-Test
This section describes the parameters for testing in transmitter mode.
User Defined