Rohde & Schwarz EVSG1000, Руководство пользователя

Страница: 141 / 311

GBAS/SCAT-I Mode (Options R&S EVSG-K4/-K5)
R&S
®
EVSG1000
141 User Manual 1178.6227.02 ─ 04
7.4.4 Bandwidth Configuration
Access : [BW]
Access VNC : [e]
IF Filter
The IF filter determines the bandwidth on which the measurement is performed. The
default filter bandwidth is 16.8
kHz. For GBAS/SCAT-I measurements, the complete
channel bandwidth is 25 kHz.
7.4.5 General Configuration
Access : [Config]
Access VNC : [S]
PPS SRC .................................................................................................................... 141
Export xml ................................................................................................................... 141
Import xml ................................................................................................................... 141
DEC DEF .................................................................................................................... 141
Reset BER .................................................................................................................. 141
PPS SRC
Source of the PPS signal required as a time reference
"TRIG" Signal provided at the Trigger In connector
"PPS SMA" Signal provided at the PPS In connector
"PPS GPS" Signal provided at the RS232-GPS connector
Export xml
Exports the internal message type xml definition to a connected USB storage device
(see
Chapter 7.5, "Message XML Interface" , on page 142).
This is useful to create a customized definition without having to start from an empty
file.
Import xml
Imports a customized message type xml definition from a connected USB storage
device to the R&S
EVSG1000 (see Chapter 7.5, "Message XML Interface" ,
on page 142).
Note that this definition is only used if you set DEC DEF to "Custom".
DEC DEF
Determines which message type xml definition the decoder uses.
"Default" Uses the definition stored internally on the R&S EVSG1000
"Custom" Uses the imported definition (see "Import xml" on page 141).
Reset BER
Resets the values for the following measurement results:
GBAS/ SCAT-I Measurement Configuration