Remote Control
R&S
®
ESRP
870
User Manual 1175.7445.02 ─ 08
Example:
INIT:CONT OFF
Selects single sweep operation
CORR:COLL THR;*WAI
Starts the measurement of reference data using direct connec-
tion between generator and device input and waits for the sweep
end.
Usage:
Setting only
SCPI confirmed
Manual operation:
See
See
[SENSe:]CORRection:METHod
<Type>
This command selects the type of measurement to be performed with the tracking gen-
erator.
The command is available if a tracking generator is installed and has been turned on.
Parameters:
<Type>
REFLection
Selects reflection measurements.
TRANsmission
Selects transmission measurements.
*RST:
TRANsmission
Example:
CORR:METH TRAN
Sets the type of measurement to "transmission".
Manual operation:
See
See
See
[SENSe:]CORRection:RECall
This command restores the measurement configuration used for calibration.
The command is available if a tracking generator is installed and has been turned on.
Example:
CORR:REC
Usage:
Event
SCPI confirmed
Manual operation:
See
[SENSe:]CORRection[:STATe]
<State>
This command turns correction of measurement results (normalization) on and off.
The command is available after you have defined a reference trace for the selected
measurement type with
[SENSe:]CORRection:COLLect[:ACQuire]
Remote Commands to Control the Tracking Generator