System Configuration
R&S
®
ESRP
484
User Manual 1175.7445.02 ─ 08
IP Address ← Network Address ← General Setup
Opens an edit dialog box to enter the IP address via the keypad. The TCP/IP protocol
is preinstalled with the IP address 10.0.0.10. If the DHCP server is available ("DHCP
On"), the dialog box entry is read-only.
The IP address consists of four number blocks separated by dots. Each block contains
3 numbers in maximum (e.g. 100.100.100.100), but also one or two numbers are
allowed in a block (as an example see the pre-installed address). For step-by-step
instructions, refer to
Chapter 11.2.5.2, "Assigning the IP Address"
Subnet Mask ← Network Address ← General Setup
Opens an edit dialog box to enter the subnet mask via the keypad. The TCP/IP proto-
col is preinstalled with the subnet mask 255.255.255.0. If the DHCP server is available
("DHCP On"), the dialog box entry is read-only.
The subnet mask consists of four number blocks separated by dots. Each block con-
tains 3 numbers in maximum (e.g. 100.100.100.100), but also one or two numbers are
allowed in a block (as an example see the preinstalled address). For step-by-step
instructions, refer to
Chapter 11.2.5, "Setting Up a Network (LAN) Connection"
DHCP (On/Off) ← Network Address ← General Setup
Switches between DHCP server available ("On") or not available ("Off"). If a DHCP
server is available in the network, the IP address and subnet mask of the instrument
are obtained automatically from the DHCP server. For further details, refer to
ter 11.2.5, "Setting Up a Network (LAN) Connection"
LXI ← General Setup
Opens the LXI submenu containing the following softkeys:
●
●
●
●
LXI functionality is available only for user accounts with administrator rights.
Info ← LXI ← General Setup
Shows the current LXI parameters, including the current version, class and various
computer parameters like the computer name or IP address.
While active, the dialog is not updated.
LXI functionality is available only for user accounts with administrator rights.
Remote command:
Password ← LXI ← General Setup
Shows the currently set password. You can also change the current password using
this softkey.
The password is required to change settings via the web browser (e.g. IP parameter).
An empty password is not valid, i.e. you must enter a password.
By default, the password is
LxiWebIfc
.
Instrument Setup and Interface Configuration – SETUP Key