Spectrum Measurements
R&S
®
ESRP
322
User Manual 1175.7445.02 ─ 08
3. In zero span, the span corresponds to the sweep time. In that case, press the
softkey and enter a sweep time.
6.2.4
Setting the Level Display and Configuring the RF Input – AMPT Key
The AMPT key is used to set the reference level, the level range and unit, the scaling
and the RF attenuation.
To open the amplitude menu
●
Press the AMPT key.
The "Amplitude" menu is displayed. The "Reference Level" dialog box is displayed.
Menu and softkey description
●
Chapter 6.2.4.1, "Softkeys of the Amplitude Menu"
Tasks
●
Chapter 6.2.4.2, "Specifying the Amplitude"
6.2.4.1
Softkeys of the Amplitude Menu
The following table shows all softkeys available in the "Amplitude" menu. It is possible
that your instrument configuration does not provide all softkeys. If a softkey is only
available with a special option, model or (measurement) mode, this information is pro-
vided in the corresponding softkey description.
Functions to configure the amplitude described elsewhere:
●
●
●
........................................................................................323
..........................................................................................323
..........................................................................................323
............................................................................................324
............................................................................................324
........................................................................................324
............................................................................................ 324
............................................................................................. 325
Configuration