Receiver Mode
R&S
®
ESRP
153
User Manual 1175.7445.02 ─ 08
RF Att;10.000000;dB
RF attenuation level in scan range <x>
Auto Preamp;OFF;
Auto preamplification state for scan range <x>
Preamp;0.000000;dB
Preamplification state for scan range <x>
TRACE <x> FINAL
Peak list contents for trace <x> after scan [or final
measurement]
Trace Mode;CLR/WRITE;
Trace mode for trace <x>
Detector;QUASI PEAK;
Detector for trace <x>
x-Unit;Hz;
Unit of the x-axis
y-Unit;dBµV;
Unit of the y-axis
Final Meas Time;1.000000;s
Final measurement time
Margin;6.000000;dB
Margin of the peaks
Value;26;
Number of result values
1;2150000.000000;84.210000;;;
Peak list entries:
1;6150000.000000;84.210000;;;
<Trace>;<Frequency>;<Level>;<DeltaLi-
mit>;<Phase>;<Unused>
etc.
5.2.9
Formats for Returned Values: ASCII Format and Binary Format
ASCII Format (FORMat ASCII)
The command reads out a list of comma separated values (CSV) of the measured val-
ues in floating point format.
Reading out data in binary format is quicker than in ASCII format. Thus, binary format
is recommended for large amounts of data.
Binary Format (FORMat REAL,32)
The command reads out binary data (Definite Length Block Data according to IEEE
488.2), each measurement value being formatted in 32 Bit IEEE 754 Floating-Point-
Format.
Depending on the number of samples to be transferred, 2 different kinds of syntax are
used:
For
<
10
10
samples:
The schema of the result string is as follows:
#<NoOfDigits><NoOfDataBytes><value1><value2>…<value n>
, with
Measurement Basics