Rohde & Schwarz 1424.7005K02, Начало работы

Страница: 28 / 34

Instrument tour
R&S
®
NRX
28 Getting Started 1424.7070.02 ─ 09
Further information:
●
Chapter 5.2.5, "AC supply and power switch" , on page 29
●
Chapter 4.9, "Switching on or off" , on page 21
5.2 Rear panel tour
1
2 3 4 5
6 7 8
Figure 5-2: Rear panel of the R&S NRX
1 = Sensor connectors C and D (optional), used to connect R&S power sensors, see Chap-
ter 5.2.8, "Sensor connectors C and D" , on page 31.
2 = Trig In / Out 2 and Out 1 / Trig Out connectors, see Chapter 5.2.1, "Trig In / Out 2 and
Out 1 / Trig Out connectors" , on page 28.
3 = Ethernet interface, see Chapter 5.2.2, "Ethernet interface" , on page 29.
4 = USB device interface, see Chapter 5.2.3, "USB device interface" , on page 29.
5 = USB host interface, see Chapter 5.2.4, "USB host interface" , on page 29.
6 = AC supply and power switch, see Chapter 5.2.5, "AC supply and power switch" ,
on page 29.
7 = IEC 625/IEEE 488 interface, optional, see Chapter 5.2.6, "IEC 625/IEEE 488 interface" ,
on page 30.
8 = Name plate, see Chapter 5.2.7, "Name plate" , on page 30
5.2.1 Trig In / Out 2 and Out 1 / Trig Out connectors
See (1) in Figure 5-2 .
The Out 1 / Trig Out BNC connectors supply an analog signal with a voltage
between 0 V and 2.5 V. It can be used to output a voltage that is proportional to
Rear panel tour