Preparing for Use
R&S
®
QAR
29
User Manual 1178.7200.02 ─ 09
1. Loosen the screws on the side of the support bar with an Allen wrench, size 6 (2x).
2. Turn the reflector to the right or left as necessary.
3. Repeat normalization measurement.
a) If normalization does no longer indicate a misalignment, reassemble the stand.
b) If normalization still indicates a misalignment, repeat the adjustment until the
error no longer occurs.
Correcting a vertical tilt
Solves message in user interface: "Rod alignment or rod distance is not correct".
1. Remove the cover on the top of the support bar (1x), for example with a slotted
screwdriver.
2. Loosen the screw with an Allen wrench size 6 (1x).
3. Move the support bar up or down to correct the vertical angle of the stand.
4. Repeat normalization measurement.
a) If normalization does no longer indicate a misalignment, reassemble the stand.
Installing the R&S
QAR