PS10-BRD v3.2 EN Rev.A.doc
2008-04-08
-
Battery is not connected
-
Battery has high resistance which indicates that battery is damaged
When PSAM-1 operates in networked mode it must be connected to PRxx2 series access
controller. In this mode PSAM-1 module transmits all warnings direct to the access
controller.
I
NSTALLATION
PS10-BRD should be installed on the flat surface using 4 nylon distances (delivered with
the unit), far enough from heat and moisture sources. All electrical connection should be
carried out without supply. PS10-BRD will not start operation on reserve battery, to start
operation it requires AC supply.
Warning
Do not adjust potentiometers located on PS10-BRD electronic board, these components
are factory set and should not be changed.
T
ECHNICAL
S
PECIFICATION
Parameter Value
Comments
AC supply
18-22 VAC
Alternatively, PS10-BRD might be supplied
from 24VDC
AC frequency
50..60 Hz
Power 20W
Full
load
Nominal
Output voltage
13.8 VDC
Output voltage may vary from app. 11.5
up to 13.8V depending on actual battery
charging phase.
Max. output current
(without battery)
1.2A
Maximum output current is guaranteed for
unlimited time and for entire temp. range.
During battery charging process output
current will be reduced to 0.9A
Ambient temperature
5-40 °C
Max. momentary
output current with
battery
5A
1.0A delivered by electronic circuit and
4.0A delivered by battery
Initial battery charging
current
0.3A
Battery cut off voltage
10.0V
Battery compartment
6.5Ah/12V
or 7Ah/12V
Dimensions 100x70x45
Weight ~95g
Without
battery
The symbol of a crossed-through waste bin on wheels means that the product
must be disposed of at a separate collection point. This also applies to the
product and all accessories marked with this symbol. Products labeled as such
must not be disposed of with normal household waste, but should be taken to a
collection point for recycling electrical and electronic equipment. Recycling helps to
reduce the consumption of raw materials, thus protecting the environment.
Содержание PS10-BRD
Страница 3: ...PS10 BRD v3 2 EN Rev A doc 2008 04 08 ...