Roger PR102DR, Руководство по установке

Страница: 12 / 13

PR102DR Installation Guide Rev.E.doc 2017-09-18
12/13
More information on controller programming can be found in the document Functional description
of PRxx2 series controllers as well as in PR Master User Manual, which are available at
www.roger.pl .
4.4 Firmware update
The latest versions of firmware and Roger ISP software are available at www.roger.pl . In order to
update firmware it is necessary to connect the device by means of RS485 bus to communication
interface (UT-2USB or RUD-1) and then connect the interface to PC with installed Roger ISP
software. It is not necessary to disconnect the controller from access control system, it is only
required to place FDM jumper in order to put the device in firmware download mode. Therefore
firmware update can be performed by means of RS485 bus of access control system.
Firmware update procedure
 Place jumper on FDM pins (see fig. 6)
 Reset device (press RESET button or switch power off/on)
 Start RogerISP software and select communication port (in case of RUD-1 select USB-RS485
Converter ).
 Press the button Erase
 Once more reset device (place and remove jumper on RST pins or switch power off/on)
 In Firmware window select firmware *.hex file (can be downloaded from www.roger.pl ) and
then select the button Program
 After firmware upload remove jumper from FDM pins and reset device (press RESET button or
switch power off/on)
Note: If the controller is not responding and LED SYSTEM (orange) is on after firmware update
then it is necessary to reset – see 4.2 Memory Reset procedure or update firmware once more.
Note: In case of network system, it is required to restart controller within PR Master software by
right clicking particular controller and selecting the option
Restart controller and verify
version .
5. O
RDERING INFORMATION
Table 6. Ordering information
PR102DR Access controller in enclosure adapted for installation on DIN 35mm rail.
PR102DR-BRD Electronic module of PR102DR controller.
ME-2-D Metal enclosure with 13.8VDC/3.5A power supply unit, adapted for 8 x PR102DR
controllers.
ME-5-S Metal enclosure with 13.8VDC/11A power supply unit, adapted for 18 x PR102DR
controllers.
PS-15DR 13.8VDC/1.5A power supply unit adapted for installation on DIN 35mm rail.
CPR32-NET-
BRD Electronic module of network controller .
UT-4DR Ethernet-RS485 communication interface.
UT-2USB USB-RS485 communication interface.
RUD-1 Portable USB-RS485 communication interface with 12VDC/0.12A output.