MCX16-AP Operating manual.doc
2018-11-29
8/12
Application.
Aperio locks (1-16)
Lock enabled
Parameter specifies if particular lock is enabled. Range: [0]:No, [1]:
Yes. Default value: [0]: No.
Lock ID
Parameter specifies 6-digit lock ID which is detected in Aperio
Programming Application and must be entered here. Range: 0-
FFFFFF. Default value: 0
RS 485 address
Parameter defines RS485 address assigned to the lock. The
parameter is valid only if MultiID operating mode is selected.
Range: 100-131. Default value: 101.
Terminal settings
AF type
Parameter defines authentication factor type returned by lock.
Default value: [16]: 40bit number.
AF class
Parameter defines authentication factor class returned by lock.
Default value: MFC1K.
Input types
IN1-IN8
Parameter defines the type of input line. Range: [1]: NO; [2] NC.
Default value: [1]: NO.
Output reversed polarity
OUT1-OUT6, REL1, REL2
Parameter defines if the polarity of output line is normal or
reversed. Range: [0]: No, [1]: Yes. Default value: [0]: No.
Power supply settings
Battery test period [min]
Parameter defines time between successive battery tests. Range:
10-1440. Default value: 10.
AC lost delay [min]
Parameter defines time after which lost AC supply is reported.
Available values: 5-1440. Default value: 5.
Comments for expander object
DEV, PWR, RTC, REL1-2, OUT1-6,
IN1-8
Any text or comment assigned to an object in order to facilitate its
identification in VISO software.
Comments for lock objects (1-16)
DEV, CDI, OUT, PWR
as above
Memory reset
Memory reset procedure restores default settings such as 192.168.0.81 IP address and admin
communication key.
Switch power supply off.
Press and remove memory card from expander.
Use memory card reader to connect the card to computer.
Delete Aperio.ini file from the memory card.
Insert the memory card into expander socket.
Switch power supply on.
Start RogerVDM and make low level configuration.
Firmware update
New firmware can be uploaded to the expander using RogerVDM program or by means of memory card.
Firmware update with RogerVDM software
Switch power supply off.
