Roger GPSR-BP, Как пользоваться инструкцией

Страница: 10 / 16

Troubleshooting
GPS receiver cannot receive signals next to the repeater.
• Check that +5VDC is present in the antenna end of the cable and in at the
antenna connector of the repeater. Broken or short-circuited cable?
• Check that repeater power is on and LED is on.
No LED indication on GPS Repeater
• Check that +12VDC is present in the wall power adapter connector
• Check that power is available in the wall connector where power adapter
is connected
LED turns RED and GPS coverage is lost.
• Check that outdoor receiving antenna is in a location where it cannot
receive signals from the repeater
• Try turning down the gain setting
• Check that there are no interference signals close to the receiving antenna.
The system is very sensitive to interference at the GPS L1 frequencies
(1575.42+/-20 MHz)
Small indoor coverage radius
• Check that outside antenna is correctly positioned
• Check that there are no interference sources close to the receiving antenna
• Check gain setting
• Check the repeater positioning
• Are there obstacles that could limit signal coverage?
• Shorter cable run or a line amplifier can improve signal level slightly
• Signal splitter and additional repeater units may be required to cover
a larger or obstructed areas
Figure 2: Wideband gain. NOTE: Attenuation outside the 1.575GHz passband is
typically better than –60dB. Graph indicates lower attenuation due to measurement
setup (spectrum analyzer noise floor).
10. 11.