Roger Technology H70/200AC, Инструкции и предупреждения для установщика, Страница: 74 / 272

EN
74
15
Safety input and command status (TEST mode)
;MXLRSGYVVIRXP]EGXMZIGSQQERHWTVIWWXLI8)78FYXXSRERHGLIGOXLIJSPPS[MRK
DISPLAY POSSIBLE CAUSE ACTION BY SOFTWARE PHYSICAL CORRECTIVE ACTION
The safety STOP contact is open.
-
Install a STOP button (NC) or jumper the
ST contact with the COM contact.
Sensing edge COS1 not connected
or incorrectly connected.
Set the parameter if not used
or to disable.
Jumper contact COS1 with contact COM ,
if not used or to disable
Sensing edge COS2 not connected
or incorrectly connected.
Set the parameter if not used
or to disable.
Jumper contact COS2 with contact COM ,
if not used or to disable.
Photocell FT1 not connected or in-
correctly connected.
Set the parameter e if
not used or to disable.
Jumper contact FT1 with contact COM , if
not used or to disable. Check connection
referring to relative connection diagram
Photocell FT2 not connected or in-
correctly connected.
Set the parameter e if
not used or to disable.
Jumper contact FT2 with contact COM , if
not used or to disable. Check connection
referring to relative connection diagram
)(
At least 3 limit switches in open con-
tact state or not connected.
-
Check connection of limit switches.
)$
Both gate leaves at open limit switch.
-
-
Open limit switch not connected.
-
Check connection of limit switches.
)&
Both gate leaves at closed limit
switch.
- -
Closed limit switch not connected. - Check connection of limit switches.
)
LEAF 1 limit switches not connected
or incorrectly connected.
-
Check connection of limit switches.
)
LEAF 2 limit switches not connected
or incorrectly connected.
-
Check connection of limit switches.
LEAF 1 open limit switch not con-
nected or incorrectly connected.
Or LEAF 1 is open.
-
Check connection of limit switches.
LEAF 1 closed limit switch not con-
nected or incorrectly connected.
Or LEAF 1 is closed.
-
Check connection of limit switches.
LEAF 2 open limit switch not con-
nected or incorrectly connected.
Or LEAF 2 is open.
-
Check connection of limit switches.
LEAF 2 closed limit switch not con-
nected.
Or LEAF 2 is closed.
-
Check connection of limit switches.
SS
If occurs with no voluntary com-
mand, the contact (N.O.) may be
faulty or one of the buttons may be
incorrectly connected.
-
Check PP - COM contacts and connec-
tions to buttons.
&+
-
Check CH - COM contacts and connec-
tions to buttons.
DS
-
Check AP - COM contacts and connec-
tions to buttons.
SH
-
Check PED - COM contacts and connec-
tions to buttons.
2U
If occurs with no voluntary com-
mand, the contact (N.O.) may be
faulty or the timer may be incorrectly
connected.
-
Check ORO - COM contacts. Contact
must not be jumpered if not used.
N.B. Press TEST button to exit from the TEST Mode.
We recommend troubleshooting safety device and input status errors with “corrective action by software” only.