EN
63
13
Safety input and command status (TEST mode)
;MXLRSGYVVIRXP]EGXMZIGSQQERHWTVIWWXLI8)78FYXXSRERHGLIGOXLIJSPPS[MRK
DISPLAY
POSSIBLE CAUSE
ACTION BY SOFTWARE
PHYSICAL CORRECTIVE
ACTION
The safety STOP contact is
open.
Install a STOP button (NC) or jump
er the ST contact with the COM
contact.
Sensing edge COS not con
nected or incorrectly connected.
Set the parameter
if not
used or to disable
Jumper contact COS1 with contact
'31MJRSXYWIHSVXSHMWEFPI
Photocell FT1 not connected or
incorrectly connected.
Set the parameter
e
if not used or to disable
Jumper contact FT1 with contact
'31 MJ RSX YWIH SV XS HMWEFPI
Check connection referring to rela
XMZI GSRRIGXMSR HMEKVEQ ƼKYVIW
Photocell FT2 not connected or
incorrectly connected.
Set the parameter
e
if not used or to disable
Jumper contact FT2 with contact
'31 MJ RSX YWIH SV XS HMWEFPI
Check connection referring to rela
XMZI GSRRIGXMSR HMEKVEQ ƼKYVIW
)(
Both limit switches in open con
tact state or not connected.
Check connection of limit switches.
)$
Door is at door closed limit
switch.
Door open limit switch absent or
not connected.
Check connection of limit switches.
)&
Door is at door closed limit
switch.
Door closed limit switch absent
or not connected.
Check connection of limit switches.
SS
If occurs with no voluntary com
QERHXLIGSRXEGX23QE]FI
faulty or one of the buttons may
be incorrectly connected.
'LIGO44'31GSRXEGXWERHGSR
nections to buttons.
&+
'LIGO','31GSRXEGXWERHGSR
nections to buttons.
DS
'LIGO%4'31GSRXEGXWERHGSR
nections to buttons.
SH
'LIGO4)('31GSRXEGXWERHGSR
nections to buttons.
N.B.
Press
TEST
button to exit from the
TEST
Mode.
We recommend troubleshooting safety device and input status errors with “corrective action by software” only.
Содержание B70/2B
Страница 2: ...2 ...
