Rodia UDK68, Руководство по эксплуатации

Страница: 10 / 20

10
RODIA
®
UDK68
GB
parts, breakage of parts and any
other condition that may affect the
power tool’s operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool
for operations different from those
intended could result in a hazardous
situation.
5) Battery tool use and care
a) Recharge only with the charger
specified by the manufacturer. A
charger that is suitable for one type of
battery pack may create a risk of fire
when used with another battery pack.
b) Use power tools only with specifically
designated battery packs. Use of any
other battery packs may create a risk
of injury and fire.
c) When battery pack is not in use, keep
it away from other metal objects, like
paper clips, coins, keys, nails, screws
or other small metal objects, that can
make a connection from one terminal
to another. Shorting the battery
terminals together may cause burns or
a fire.
d) Under abusive conditions, liquid may
be ejected from the battery; avoid
contact. If contact accidentally occurs,
flush with water. If liquid contacts
eyes, additionally seek medical help.
Liquid ejected from the battery may
cause irritation or burns.
6) Service
a) Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
SPECIAL TOOLS SAFETY
WARNINGS
Wear safety glasses and
ear protectors.
Before working on the machine
itself, pull the mains plug.
Be careful of hidden electrical
lines or gas and water pipes.
Check the working area, e. g.,
with a metal detector.
Pay attention to the power
supply
• On construction sites electrical appli-
ances should be connected to spe-
cially designed power supplies. Suita-
ble are grounded main power supplies
equipped with an earthleak switch of
max. 30mA or separating transformers.
• Non-grounded common household or
similar power outlets are not suited as
a power source. For wet cutting or drill-
ing machines stricter safety standards
are applicable. For extra safety the
machine must be connected by one of
the following methods:
– Main power supply equipped with
earthleak switch 30 mA; or
– Separating transformer, only 1 machine
may be connected at any given time;
or
– With an intermediate cable equipped
with a PRCD safety switch of max.
30mA.