17
RODIA
®
350 RS SERIES
GB
Cooling system
ATTENTION! Operating the
water pump without a sufficient
supply of water may result in
pump damage.
• Place the plug in the drain of the water
container .
• Fill up the container with water until the
water pump is completely submerged .
Connecting to power supply
First, check whether:
• the line voltage corresponds with the
data on the machine’s specifications
plate,
• there is a grounded power supply,
• the extension cord wire cross-section is
at least 2,5 mm² .
Motor protection
The motor is equipped with a thermal
safety switch for protection against
an overload . When the motor gets
overheated the switch falls back into its
initial position and can only be switched
on again after the motor is cooled down .
The switch is also protecting against
power failure . When the power returns,
the motor will not start on its own but must
be switched on by hand .
Installing the saw blade
WARNING! Make sure you dis-
connect the machine from the
power supply before fitting or
switching the saw blade or when
performing any maintenance on
the machine.
• Remove the three knobs of the blade
cover .
• Block the sawing spindle with the 6
mm . Allen wrench .
• Unscrew the 22 mm . hexagon nut
with the wrench and remove the saw
flange . (Attention: Left-handed screw
thread .)
• Clean the saw flanges .
• Fit the saw blade on the centre ring of
the motor flange . (Check the direction
of rotation and make sure the blade is
well centred)
• Mount saw flange and tighten with the
hexagon nut .
VARIOUS SAWING
PROCESSES
One-step sawing
(Use only original saw blades as advised
by the manufacturer)
• Move saw head down until the saw is
approx . 10 mm . below the saw table .
• Secure saw head with the knob .
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop .
