9
GB
Operating Parameters
Programming instructions for the Märklin* 6020/6021
The vehicle is able to detect numerous operating parameters. All of the parameters are stored in so-called
CVs (Configuration Variables). These can be modified in a targeted manner, independent from the control
unit which is used. You will find a list of the CVs at the end of these instructions.
With a Märklin* unit, it is possible to programme all of the CVs but not read them out.
The travel controller is to be set to “0“.
No locomotives are to be on the track with the exception of the locomotive which is to be programmed!
Observe the flashing of the locomotive lights when programming.
Any number of changes/settings can be made as long as the decoder is in the programming mode.
1.
Press the
STOP
and
GO
keys simultaneously until a reset is carried out
2.
STOP
key to deactivate the track voltage
3.
Enter address 80
4.
Press
the direction of travel changeover switch and
keep it pressed in
, then additionally press
GO for min. 0.5 sec.
so as to reactivate the track voltage
5.
The decoder is in programming mode = slow flashing
6.
Enter the register which is to be changed (two-digit in the address field)
7.
Confirm by pressing the direction of travel changeover switch = rapid flashing
8.
Enter the required value (two-digit in the address field)
9.
Confirm by pressing the direction of travel changeover switch = slow flashing
Repeat 5-9 is additional CVs are to be programmed.
If the programming is to be terminated, set the unit to “STOP“ or enter the address “80“ before briefly confir-
ming the direction of travel change.
As only entries of 01 to 80 are possible when programming using a Motorola** digital unit from Märklin*, the
value “0“ has to be entered as “80“ above the address.
Programming instructions for the Märklin* “Mobile Station“ and “Central Station“
No locomotives are to be on the track with the exception of the locomotive which is to be programmed!
1.
Press the
ESC
key
2.
Select the “New Loc“ menu item
3.
Select the “Database“ menu item
4.
Select the article number “36330“ with the rotary knob
5.
Press the
ESC
key on the Mobile Station again
6.
Select the “change Loc“ menu item
7.
The Märklin* address can be selected in the “Address“ menu item
8.
The locomotive name can be changed in the “Name“ menu item
The functions F1- F4 can be called up with the 4 left keys on the Mobile Station. The top key hereby corres-
ponds to function F1. The activated functions cannot be shown on the display however.
Should the programming also fail after a second attempt by way of exception, please reset the decoder
either by programming CV08 with the value 08 or CV59 to the value 01!
8010732920 VII_2009.indd 9
13.08.2009 09:10:55
