BACKING PAD REPLACEMENT
• To replace the 6” PSA (pres-
sure sensitive adhesive)
Backing Pad, place a 5/8”
Wrench (not included) on the
Hex of the Arbor Shaft
(FIG 4)
while gripping the Backing Pad
in your fingers and loosen in a
counter-clockwise direction.
• Place replacement Backing Pad
threaded arbor into the 5/16”-
24 female threaded output
shaft then use a 5/8” Wrench
(not included) to hold the shaft
while the pad is tightened.
MAINTENANCE
• Before each use, add a few drops of a quality air tool oil (not included).
• If tool is to be unused for an extended period, add 10 drops of air tool oil directly to the
air inlet then store the tool, inlet up.
• With the air supply disconnected, periodically check that the backing pad is tight.
To order parts and supplies: 800.343.9353 >> eastwood.com
7
FIG. 4
INJURY HAZARD!
Disconnect air supply from the tool to prevent accidental starting and
potential injury while installing or removing Backing Pad.
Be sure the Backing Pad is securely tightened on the output shaft before
operating tool.
