Rockwell ShopSeries RS4503, Руководство пользователя

Страница: 8 / 13

7
MULTI FUNCTION CAR POLISHER EN
SYMBOLS
To reduce the risk of injury, user must read
instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Double insulation
RCM MARKING
TECHNICAL DATA
Rated voltage
Rated input power
No-load speed
Max. pad diameter
Protection class
Machine weight
230-240V~ 50Hz
600W
1500-6800/min
Ø180mm
/II
2.46kg
OPERATING INSTRUCTIONS
1. ASSEMBLING OR CHANGING THE SANDING PAD (See
Fig.A1-A2)
WARNING: DISCONNECET POLISHER FROM
POWER SOURCE.
Assembly of the Sanding Pad
1. Take off the rubber cap from the Sanding Pad (4).
2. Position the Spanner (a) (supplied with polisher)
to engage the flats (b) on the spindle.
NOTE: It may be necessary to rotate the Sanding
Pad (4) (by hand) to expose the spindle flats.
3. While holding the spindle with the Spanner,
rotate the Sanding Pad clockwise (by hand) to
tighten it.
Changing The Sanding Pad
1. Position the Spanner (a) (supplied with polisher)
to engage the flats (b) on the spindle.
2. While holding the spindle with the Spanner,
rotate the old Sanding Pad counterclockwise (by
hand) to remove it.
3. Install a new Sanding Pad as above instruction
‘ Assembly of the Sanding Pad ’.
2. FITTING THE SANDING PAPER (NOT SUPPLIED) OR
FOAM DISC (See Fig. B1, B2)
Sanding Paper (not supplied)/ or Foam disc is easily
attached on the pad of your polisher. Fit the paper/
pad over the plate so that it covers the entire area,
push and slightly twist to make sure the coated
Sanding Paper/ or Foam disc is even on the plate.
NOTE: Make sure the Sanding Paper/ or Foam disc is
even with the edges and that it’s centrosymmetric,
otherwise the polisher vibrates badly.
Remove the abrasive Sanding Paper/ or Foam disc
by pinching an edge and peeling it off.
3. SPREAD THE POLISH (See Fig. C)
Spread about a tablespoonful of polish evenly over
the entire surface of the pad cover. Do not apply
polish directly to car. This first application should do