Rockwell RS8020, Инструкция по эксплуатации

Страница: 12 / 20

PETROL GRASS TRIMMER 26cc EN
12
7. Do not overreach. Keep proper footing and
balance at all times. Overreaching can result in
loss of balance or exposure to hot surfaces.
8. Mix and store fuel in an approved container.
9. Mix fuel outdoor where there are no sparks or
flames. Move at least 10 feet (3 metres) away from
where you refueled before starting engine.
10. Never smoke or use exposed light bulbs into the
area while refueling.
11. Always mop up fuel spillage as quickly as
possible. Change your clothes if you spill fuel on
yourself.
12. Stop the engine to cool. Empty the fuel tank and
secure the unit before transporting in a vehicle.
13. Always keep feet and hands well away from the
cutting line, take special care when starting.
14. Always stop the engine and remove the spark
plug wire before making any adjustments.
15. Never leave the machine running and
unattended.
16. Replace cutting head if cracked, chipped, or
damaged in any way. Be sure the line spool is
properly installed and securely fastened. Failure
to do so can cause serious injury.
17. Make sure all guards, straps, debris shield and
handles are properly and securely attached.
18. Do not use any other cutting attachment with this
machine.
19. Do not use metal blades (if applicable).
20. When unloading the trimmer from the truck, be
careful not to drop the engine on the ground as
this may severely damage the fuel tank.
21. Except in case of emergency, never drop or
throw the trimmer to the ground as this may
severely damage the trimmer.
22. Remember to lift the entire equipment from the
ground when moving the equipment. Dragging
the fuel tank is highly dangerous and will cause
damage and leakage of fuel, possibly causing fire.
wARNING! This product is operated with -
unleaded petrol 40 parts to one (40:1) part
two stroke oil.
Incorrect oil or petrol will lead to failure and
damage.
Specific Safety Rules for Trimmer Use
Maintain a firm grip on both handles while trimming.
Keep bump head below waist level. Never cut with
the bump head located over 76cm (30in) or more
above the ground.
SAfETy INSPECTION
1. Look around the engine for signs of oil or petrol.
Wipe up any spills before starting the engine.
2. Replace any damaged parts.
3. Check that all fasteners, guards and handles etc
are in place and secure. Tighten as necessary.
4. Check the fuel level. Starting with a full tank
will help to eliminate or reduce operating
interruptions for refueling.
MAINTENANCE INSPECTION
1. Check the air filter. A dirty air filter will restrict
airflow to the carburetor, reducing engine and
cutting performance.
2. Check the throttle cable free play. The cable must
be correctly adjusted and operate smoothly for
good throttle control.
3. Look for signs of damage to cutting blade.
Replace the blade or if any part is worn, bent,
cracked, chipped, or damaged in any way.
4. Make sure the guards are properly installed and
securely fastened.
5. If the guards are damaged in any way replace
immediately.